2 Kg Micro Extinguishing

Working principle; It starts with the release of nitrogen gas as a result of the piercing of the pipe detector (Tubing) made of polymer under 12 bar pressure with nitrogen at approximately 100 ° C and opening the valve on the cylinder at the same time. Also, no fire alarm system is required. In direct systems, there is no need for a nozzle and pipe system. Parts up to 8.5 m³ are protected with a single system. The nitrogen released by the piercing of the polymer pipe detector against the heat also enables the valve on the cylinder to be opened. With the opening of the valve, The extinguishing agent leaves the cylinder and the pipe exits the detector's punctured point and sprays towards the source of fire causing the detector to rupture. It spreads over the entire volume and extinguishes the fire in approximately 3-5 seconds. It is low cost. It is an inexpensive solution because instead of extinguishing the entire room, only the cabinet that may be the source of fire is extinguished. It is very efficient because the fire is extinguished directly at its source. Its assembly is done in a very short time and easily. This system is widely applied in control panels, machine electrical boxes, CNC and EDM machines where Clean Gas Suppression Systems are difficult and costly to apply. It provides a great advantage to be applied without hydraulic calculation (Pre-engineered). With the Tubing System, both detection and extinguishing can be done with a single installation. In addition, thanks to the flexibility of the tubing system, it provides ease of installation in narrow and difficult to reach areas. Usage areas - Electric panels, Small computer systems.